Muratec MFX-1950 - Manual (Page 133)

8-5 s
pecIaL features
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
s
p
e
c
Ia
L
f
e
a
t
u
r
e
s
Creating or modifying a macro
1
Press .
1.Set Macro

/  /Enter
2
Press .
Select Macro Key
M1:No Command Stored
3
Press the macro key you want to create or modify.
Then press .
4
If you are creating a new macro, skip to next step.
If you are modifying a macro already stored, the following two displays will appear.
M1:Overwrite?
Yes  Enter
M1:Overwrite?
No  Cancel
• To overwrite the recording, press .
• To change only the macro name, press and go to the step 9.
5
The copy standby display appears and the machine begins to beep which indicates the
machine is in the macro programming mode.
Copy Ready 01
Auto Ltr 100%
6
Press the keys exactly as you would if performing a normal operation.
• The machine beeps during programming to confirm macro programming mode.
• You can program up to 60 steps. When you exceed 60 steps, the machine asks if
you want to register the operations you have entered.
Too Many Steps
Yes  Enter
Too Many Steps
No  Cancel
If you want to register them, press .
If you want to abort, press .
• When you press or at the end of the operation you are program-
ming, the machine shows:
Include Start/Enter?
Yes  Enter
Include Start/Enter?
No  Cancel
If you want the machine to start the programmed operation immediately by press-
ing the macro key, press .
If you want the machine to prompt you press or before starting
the recorded operation, press . Then go to the step 8.
7
Press .
M1:Name ;Upper
_
The machine prompts you to enter the name of macro.
If you do not want to enter or change it, skip to the step 9.