Muratec MFX-1950 - Manual (Page 154)

10-4 u
ser settInGs
Fax settings
The fax settings allows you to customize various fax settings to match your needs.
Accessing the fax settings
1
Press
[Program] No.22_
2 Fax Settings
2
Press .
[Program] No.2201
01 Scan Parameters
3
Use or
to search the item you want to set or change and press .
4
Change settings and press . For details of each setting, refer to the table
below:
5
When you have finished, press to return to the standby mode.
The underlined settings are factory defaults.
01. Scan Parameters Resolution You can choose one of the following.
Normal Scan at 8 dots/mm × 3.85 lines/mm
Fine Scan at 8 dots/mm × 7.7 lines/mm
S-Fine Scan at 8 dots/mm × 15.4 lines/mm
Gray Scan at 8 dots/mm × 7.7 lines/mm
Contrast You can choose one of the following.
Normal, Dark, Darkest, Light or Lightest.
S-Fine Resol. You can choose one of the following.
400dpi, 600dpi
02. Print Parameters Rx Reduc. Rate See page 5-6.
Auto Automatically reduces printouts at variable
rates down to a minimum of 50%. Tries to
reduce printout to fit on one sheet of your
selected paper size. If it can’t, print the
received document at 100% size on two or more
pages.
100% Does not reduce the received documents.
Margin Sets the reduction margin for Auto reduction. (00 to 85 mm)
40 mm
Half Page Recpt.*
Off Will not combine the half-page receptions.
On Combines two of half-page receptions onto a
single sheet.
* When the MFX-1950, the following menu will be displayed.
Paper Save
Off Will not perform either half-page receptions or
duplex receptions.
H.Page Rx Combines two half-page receptions onto a single
sheet.
Duplex Rx Combines and prints the received two one-sided
pages onto both sides of a single sheet.