Muratec MFX-1950 - Manual (Page 72)

4-6 s
endInG faxes
Real-time transmission (non memory transmission)
Your machine will simply dial the other fax and when it makes contact, your machine
will feed the document through, scanning and transmitting real time
• With real time transmission, you can watch each page as it is scanned and sent.
To perform a real time transmission:
1
Switch to the fax mode by pressing <
copy 4 fax 4 scan
>.
2
Place the document on the ADF.
NOTE: • The document glass cannot be used for real time transmission.
• The document glass is available only for the MFX-1950.
3
Obtain a dial tone, either by:
• Pressing repeatedly until “Monitor” appears, and then
press .
– or –
Pressing the “Monitor” soft key
–or–
• Lift the handset if you have connected an external telephone to your machine.
In either case, the machine shows:
** Tel Mode **
_
– or –
Press repeatedly until “Memory Tx” appears and press
. Then select “Off” and press to turn off the memory transmission.
– or –
If you assigned “Memory Tx” to a soft key (page 8-2), turn off the memory transmission
by simply pressing that key.
NOTE: “Monitor” is a default soft key on the F-315.
4
Dial the fax number.
• Use the numeric keys to dial the number.
–or–
• Press a one-touch key. (See page 3-6.)
–or–
• Press and three-digit code. (See page 3-8.)
–or–
• Use the phone directory dialing. (See page 3-11.)
NOTE: With real time transmission, only one destination can be dialed.
5
When you hear fax tones from the remote unit, press .
If a person answers the phone, use the handset to tell that person that you are trying
to send a fax. When you hear fax tones, press .
If the call fails and you used “Monitor” to dial, press repeatedly
until “Monitor” appears, then press or press the “Monitor” soft key to hang up.
If you are using the handset, hang up after pressing .
NOTE: To cancel the transmission, use Review commands features. (See page 4-8.)