Muratec MFX-1950 - Manual (Page 44)

2-6 G
ettInG started
Function menu
level one
Function menu
level two
Function menu
level three
Description Setting Page
2. User
Settings
1. Machine
Settings
07. Primary
Mode
You can set the primary standby mode. Scan
Copy
Fax
10-3
08. Service
Mode
For technical support. Do not turn this
setting on unless an authorized techni-
cian asks you to do so.
Off
On
10-3
09. Date & Time Sets the current date and time — 10-3
10. Paper
Source
Selects the paper source for faxing or
copying.
Fax
Copy
Fax/Copy
Not Used
10-3
11. Page
Counter
Displays the total number of pages you
have printed and scanned.
— 8-8
2.Fax
Settings
01. Scan
Parameters
You can set the following settings for fax
sending.
• Primary fax resolution
• Primary scanning contrast
• Super fine resolution
Normal, Fine,
S-Fine, Gray
Lightest, Light,
Normal, Dark,
Darkest
400dpi, 600dpi
10-4
02. Print
Parameters
You can set the following settings for fax
reception.
• Reduction rate
• Reduction margin
• Half-page reception*
* For the MFX-1950(with standard
duplex unit), the following menu is
displayed.
• Paper save function
Auto, 100%
40 mm (00-85 mm)
Off, On
Off, H. Page Rx, Duplex
Rx
5-7
10-4
03. # Of Rings Sets the number of rings before your
machine answers.
02 times (00-10 times) 5-6
10-5
04. Redial Sets the number of times and dial inter-
val for automatic fax redialing.
02 times (00-14 times)
1 min. (0-5 min.)
10-5
05. Dialing
Pause
Sets the dialing pause length. 02 sec. (00-10 sec.) 10-5
06. Memory Tx Turns memory transmission on/off. Off
On
4-3
10-5
07. Quick Tx Turns quick memory transmission on/off. Off
On
4-3
10-5
08. Select TTI Selects the TTI you want to use. TTI Default
TTI1
TTI2
TTI3
Off
4-17
09. ECM Mode Turns ECM mode on/off. Off
On
10-5
10. Block Junk
Fax
Rejects unauthorized incoming faxes. Off
Mode1
Mode2
Mode3
5-9