Muratec MFX-1950 - Manual (Page 87)

4-21 s
endInG faxes
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
s
e
n
d
In
G
f
a
x
e
s
Using alternative telephone network service providers (Dial prefix)
When you make a call, you may want to use alternative telephone network service pro-
vider to take advantage of low rates.
The following information describes how to program the access number.
1
Press
Dial Prefix No
_
2
Enter the telephone network access number using the numeric keys.
Access numbers may contain up to 40 digits.
If you must wait for another dial tone at the dialing, enter a pause at the end of the
access number by pressing repeatedly until “Pause /Dial Opt.”
appears and press or press the soft key. (Refer to
“Special dialing characters,” page 3-3.)
3
Press to save it.
4
Press to exit and return to standby mode.
NOTE: “Pause /Dial Opt.” has been assigned to soft key on the F-315 as default.
Sending faxes with the Dial prefix feature
To dial using the numeric keys
1
Place the document on the ADF or document glass.
2
Press repeatedly until “Dial Prefix(/N)” appears then press
to enter an “/N”.
– or –
If you assigned “Dial Prefix” to a soft key (page 8-2), simply press that key.
This symbol indicates access to the alternative telephone network.
Press Start
/N_
3
Enter the fax number using the numeric keys.
4
Press .
NOTE: • You must enter the full National Code telephone number when dialing telephone
numbers via any network.
• You can assign the “Dial prefix” to a soft key (page 8-2) to enter an “/N”, but it can-
not be combined with any one-touch key or speed-dial number for dialing. In order
to send faxes using the one-touch key or speed-dial number, you must instruct
your machine to access the alternative telephone network when you store the fax
number into your autodialer.
To enter an access number into your autodialer:
Before entering a fax number, press repeatedly until “Dial
Prefix(/N)” appears then press to enter an “/N”. And then, enter the fax
number.
• The document glass is available only for the MFX-1950.