Motorola MICOM-2ES/2RS/2TS ALE - Manual (Page 43)

New ALE Features
Using Autodial
The Autodial feature lets you use a single digit to call a preprogrammed address.
There are ten programmable Autodial addresses, where each can include a message.
See Auto Dial Parameters on page 61 for details on programming the Autodial list.
➤
To use Autodial to send a call:
1. Press # on the keypad.
CALL
SELECT#_
MOTOROLA
Note
If you do not select an auto-address within a few seconds, the
display automatically reverts to the previous state.
2. Press the desired preprogrammed Autodial number
(0 to 9).
The programmed address is immediately displayed;
if a message is preprogrammed, an exclamation sign
will appear before the station name.
Press
PAGE (F2) if you want to attach a message to
the call or to replace/edit a preprogrammed attached
message. See page 30.
CALL
1009
MOTOROLA
SEND PAGE CHAN MONs
Note
If the Autodial number you enter is not programmed, the message
NOT PROG will be displayed.
3. Press CHAN (F3) if you want the call to be initiated on a specific channel.
See page 30.
4. Press ENTER or SEND (F1) to start the call.
5. The radio now starts the link set up process. During this process, you will
see TO alternating with the number of the channel on which the set up
request is being sent (the channel may change, if the called station does not
answer on the first channel(s)).
Note
While the radio is initializing the link, you can press STOP (F1)
or ESC to abort the entire process.
_________________________________________________________________________________________________
29