Motorola MICOM-2ES/2RS/2TS ALE - Manual (Page 28)

MICOM-2ES/2RS/2T
1. Press MENU to display the Menu screen.
Note
If you see SCAN next to F3, first
enable the ALE functionality using
PROG > RAD > OPTS > ALE .
MENU
MOTOROLA
CHAN FREQ ALE BITs
2. Press ALE (F3).
The last active net flashes in the display.
ALE
NET 7
MOTOROLA
3. To use the displayed net, press ENTER .
To select another net:
• Press the UP / DOWN keys until you reach the required number.
or
• Use the keypad to enter the desired net number.
The new net number blinks, indicating that the
selection has not yet been confirmed.
ALE
NET 1
MOTOROLA
4. Press ENTER to confirm your choice. The radio
then starts scanning the channels in the selected net
(the changing channel number appears to the right
of the net number).
ALE
NET 1 1
MOTOROLA
CALL LQA MON
S ALE Supplement to Owner’s Guide
14
_________________________________________________________________________________________________
Entering the ALE Mode
To use the ALE mode, first it must be enabled as explained below.
Enabling the ALE Mode
➤ To enter the ALE mode:
ALE and Rx Only or Tx Only Channels
The radio will prevent users from performing calls on Rx only or Tx only channels.
This is true even when operating in the Channel mode: when selecting a Rx Only or
Tx Only channel, the ALE option is disabled (the
CALL (F1) key is not displayed
when such a channel is selected).
ALE Programming
ALE supports many features, including:
• Various type of calls
• Up to 20 nets, each with its own set of members and associated frequencies
(channels)