Motorola MICOM-2ES/2RS/2TS ALE - Manual (Page 35)

New ALE Features
MORE
PWR
(MORE, MORE, F1)
selects the transmit power level (LOW, MED, HIGH or
MAX).
MODE
(MORE, MORE, F2)
selects the operation mode (SSB, AME or PLT).
AGC
(MORE, MORE, F3)
controls the automatic gain control function (fast/slow/off).
BW
(MORE, MORE, F4)
selects the filter bandwidth,
MORE
RCLV
(MORE, MORE,
MORE, F1)
displays the receive level while F1 is pressed.
FREQ
(MORE, MORE,
MORE, F2)
displays the current frequency while F2 is pressed.
Replacing the Current Channel While in the Link State
If during an individual call you find that the channel in use is not good enough, you
can replace it with a better channel.
Note
• Channel replacement is possible only during an individual
call in the ALE mode.
• Only the initiator of a call can replace the channel in use.
➤ To replace the channel:
1. Press MORE to scroll to the second link state menu.
2. Press RPL (F1) to replace the channel in use.
3. The radio disconnects the link, replaces the channel being used, and initiates
the call once again.
Note
Even if a message was transmitted when the original link was
initiated, the new link will be initiated without the message.
_________________________________________________________________________________________________
21