Motorola MICOM-2ES/2RS/2TS ALE - Manual (Page 11)

Warnings, Cautions and Notes
Electromagnetic Interference/Compatibility
Note
Nearly every electronic device is susceptible to electromagnetic
interference (EMI) if inadequately shielded, designed, or
otherwise configured for electromagnetic compatibility. It may be
necessary to conduct compatibility testing to determine if any
electronic equipment used in or around vehicles or near fixed site
antenna is sensitive to external RF energy or if any procedures
need to be followed to eliminate or mitigate the potential for
interaction between the radio transmitter and the equipment or
device.
Facilities
To avoid electromagnetic interference and/or compatibility conflicts, turn off your
radio in any fac
i l i ty where posted not i ces instruct you t o do so. Hospitals or
health care facilities may be using equipment that is sensitive to external RF energy.
Vehicles
To avoid possible interaction between the radio transmitter and any vehicle electronic
control modules, for example, ABS, engine, or transmission controls, the radio
should be installed only by an experienced installer and that the following
precautions be used when installing the radio:
1. Refer to the manufacturer's instructions or other technical bulletins for
recommendations on radio installation.
2. Before installing the radio, determine the location of the electronic control modules
and their harnesses in the vehicle.
3. Route all radio wiring, including the antenna transmission line, as far away as possible
from the electronic control units and associated wiring.
Driver Safety
Check the laws and regulations on the use of radios in the area where you drive.
Always obey them.
When using your radio while driving, please:
• Give full attention to driving and to the road.
• Pull off the road and park before making or answering a call if driving
conditions so requ i re.
_________________________________________________________________________________________________
v