Monessen Hearth WIDEVIEW WDV500 - Manual (Page 34)

34 78D0011
WDV Series Gas Fireplace
Flame height setting for thermostatic Mode
Figure 43
1. Hold AUTO button for five (5) seconds and one number and flame icon will appear
in LCD screen.
2. Use the ON / ▲ or OFF / ▼ button to set the desired flame height to 1 (min.) 2
(medium) or 3 (max.).
3. If there is no input within three (3) seconds, the new setting will be transmitted to the
receiver. This setting only affects auto mode operation.
4. The default setting for transmitter is 2 (medium).
reMOte cOntrOl OperatIOn
°F
FP2145
3 speed fan
12/08
FP2145
Figure 44 -
3 Speed Blower Control
FP2146
blower delay timer
12/08
FP2146
Figure 45 -
Blower Delay Timer Display
3-speed Blower control (Optional)
Figure 44
nOte: Blower works automatically with flame.
1. Press FAN button once to enter blower speed setup mode at low speed initially and
one of the three blade icons will display darken on LCD display. Figure 53
2. Continue to press FAN button to set up the blower speed you desire.
3. If there is no input within three (3) seconds, the new setting will be transmitted to
receiver. If the fireplace is on, the blower speed will take effect right away; if the fire-
place is off, the receiver will remember this setting and blower is still off.
4. If you continue to press FAN button to the position that all blades are gone, the FAN
icon will disappear and turn the blower off.
Blower On Delay time and OFF Delay time setting (Default 5 ON / 8 OFF)
Figure 45
1. Hold FAN button for three (3) seconds and two (2) numbers will appear in the LCD
screen. The upper one is ON Delay Time and the bottom is OFF Delay Time in min-
utes.
2. Use the ON / ▲ button to set the desired On Delay Time from 0 to 15 minutes.
3. Use the OFF / ▼ button to set the desired Off Delay Time from 0 to 15 minutes.
FP2145
3 speed fan
12/08
FP2147
Figure 43 -
Flame Height Setting Display
3-level light Brightness control
Figure 46
1. Press LIGHT button once to change light brightness to low and one of the three levels
will display dark on LCD.
2. Continue to press LIGHT button to set up the light brightness you desire.
3. If there is no input within three (3) seconds, the new setting will be transmitted to the
receiver.
4. If you continue to press LIGHT button, the LIGHT icon will disappear and turn the
light off.
°F
FP2148
light display
12/08
FP2148
Figure 46 -
Light Brightness Display