MK Diamond Products MK-370EXP - Manual (Page 18)

18
PRE-START INSPECTION
Prior to beginning work, a pre-start inspection of the saw should be performed.
(B)
Verify the Movable Cutting
Table moves freely
(A)
Ensure the ON/OFF Switch
is in the OFF position
(C)
Inspect the Diamond Blade
for damage – verify the blade
is correct for the type of
material being cut
(E)
Inspect the MK-370EXP for
damage – ensure the cord
is free of cracks or cuts
(D)
Inspect the Pump Assembly
for damage – ensure the cord
is free of cracks or cuts
1. To prevent the possibility of electrical shock, the MK-370EXP MUST be de-
energized when connecting the Water Pump.
2. To prevent the possibility of electrical shock, use only MK Diamond authorized
replacement parts.
NOTE: To prevent pump damage, the Water Pump must be disconnected if cutting dry.
CONNECTING THE WATER PUMP
(C)
Connect the Water Pump
power cord to the connection
found on the back of the motor
(A)
Loosen the cutting head
pivot retaining knob and tilt
cutting head to 45°
WARNING
MK-370EXP SETUP
(B)
Connect the Cooling Transfer
Tube to the inlet connection
on the Blade Guard