beautypg.com

Controls and indications, Cont'), Load protected" light – MGE UPS Systems Comet TM 5 - 30 kVA User Manual

Page 18: Battery status" light, Fault" light, Load not protected" light

background image

Comet installation and user manual: E-6761200XT/FA

3.2

Merlin Gerin by MGE UPS SYSTEMS

controls and indications

(cont')

"load protected" light

21

This light indicates that Comet is
operating normally. The load is
supplied by via the inverter output 7 .
This light also goes on during normal
start-up of Comet.

"battery status" light

20

"fault" light

19

This red light indicates:

direct supply of power to the load by

AC input power via the "static bypass"

3 due to inverter 7 shutdown

(voluntary or following an overload or
an internal fault);

battery power is not available

because the battery circuit breaker 4
is in "off" position.

This orange light indicates:

inverter 7 operation on battery

power following an AC input failure or
detection of an AC input voltage
outside tolerances;

it flashes to indicate that the low

battery shutdown warning level has
been reached. If the light flashes when
the battery is not in self-operating
phase, this indicates that the battery
status should be checked by an After-
Sales representative.

21

I

+ –

!

!

O

I

+ –

!

!

O

20

I

+ –

!

!

O

19

I

+ –

!

!

O

18

"load not protected" light

18

This orange light indicates an
operating fault or an environment fault.
However, the load continues to be
supplied by the inverter 7 .