Motorola Entice W766 - Manual (Page 12)

10 essentials
To charge using the charger:
1 Insert the charger into the
micro USB connector on
your phone as shown.
2 Plug the other end of the
charger into the appropriate electrical outlet.
3 When your phone displays Charge Complete, remove
the charger.
Tip: Motorola batteries have circuitry that protects the
battery from damage from overcharging.
When you charge the battery, the battery level indicator
at the upper right of the screen shows charging
progress. At least one segment of the indicator must
be visible to ensure full phone functionality while
charging.
To charge from your computer:
You can also charge your phone’s battery by
connecting a cable from your phone’s micro USB port
to a high-power USB connector on a computer (not a
low-power one, such as the USB connector on your
keyboard or bus-powered USB hub). Typically, USB
high-power connectors are located directly on your
computer.
Both your phone and your computer must be turned
on, and you must have correct software drivers
installed on your computer. Cables and software drivers
are available in Motorola Original TM data kits, sold
separately.
turn it on & off
Press and hold the Power/End
Key ( ) until the display turns on.
The phone may require several
seconds to turn on. If prompted, use the keypad to
enter your four-digit unlock code (which, by default, is
the last four digits of your phone number) and press the
M
Key (OK) to unlock the phone.
/
M
/