Mark Levinson N32 - Manual (Page 50)

4-6
Controls and Modes Mark Levinson
If you do not press the enter button within a few seconds of
selecting the mode, the display automatically closes. If this
occurs, the selected mono mode remains selected.
3. With the MODE parameter display closed, press and release the
mono button to activate L + R mono playback.
4. Play the desired recording.
5. Press and release the balance button to display the balance con-
trol on the front panel.
The front panel balance LED lights when the balance control is
displayed.
6. Rotate the volume knob or press the volume ± buttons to cen-
ter the image between the front left and right loudspeakers.
7. When you are finished making adjustments, press and release
the balance button to close the balance control display.
If you do not press the enter button within a few seconds of
setting the balance, the display automatically closes. If this
occurs, the selected setting is automatically applied.
8. Press and release the mono button to cancel L + R mono play-
back and return to stereo playback.
Using L – R mono mode to align phono cartridge azimuth
L – R mono playback simplifies the process of aligning phono
cartridge azimuth.
To use L – R mono playback to align phono cartridge azimuth:
1. On the remote control, press and hold the mono button until
the MODE parameter is displayed on the front panel.
Press and release the mono button to cycle through all available
mono playback modes until the L – R mono mode is selected.
2. Press and release the enter button to close the MODE
parameter display.
If you do not press the enter button within a few seconds of
selecting the mode, the display automatically closes. If this
occurs, the selected mono mode remains selected.
3. With the MODE parameter display closed, press and release the
mono button to activate L – R mono playback.
4. Play the desired mono recording.