Mark Levinson N32 - Manual (Page 16)

1-8
Getting Started Mark Levinson
Power Requirements
When shipped, the Nº32 is configured for 100, 120, 220, 230 or
240VAC power operation at 50 or 60Hz. Before operating the Nº32,
make sure the ~ac mains connector label indicates the correct oper-
ating voltage for the current location.
Caution! DO NOT attempt to adjust the operating voltage. Consult an
authorized Mark Levinson dealer if the operating voltage is incor-
rect or must be changed for relocation purposes.
Different operating voltages may require the use of different
power cords and/or attachment plugs. Contact an authorized
Mark Levinson dealer for additional assistance.
Warm-up & Break-in
Period
Although the Nº32 delivers superior performance from the first
time it is powered on, this performance will continue to improve as
the Nº32 reaches its normal operating temperature and various
components “break in.” The greatest performance improvements
will occur within the first 25 to 50 hours of use. Sound quality will
continue to improve for about 300 hours.
After this initial period, performance will remain consistent unless
power is disconnected from the Nº32. Power is disconnected when
the Nº32 is powered off with the power button; the power cord is
disconnected from the ~ac mains connector or the electrical outlet;
or an extended power failure or power outage occurs. Power is not
disconnected when the Nº32 is in standby.
When power returns, it is recommended to allow the Nº32 and
other audio components to stabilize for about 2 minutes. The Nº32
will require a brief warm-up and break-in period (not the full 300
hours).
Note
When powered on with the power button, the main output
connectors mute while the Nº32 executes its initialization sequence.
The Nº32 automatically enters standby after completing its
initialization sequence.
Continuous Operation The Nº32 should be unplugged during lightning storms and
extended periods of non-use. Otherwise, it is designed for continu-
ous operation. For best performance, make sure power is connected
to the Nº32 at all times. During normal operation, do not use the
power button to power off the Nº32. Instead, use the standby
button to place the Nº32 into standby, which allows the Nº32 to
remain warmed-up to deliver optimal performance at all times.