Mark Levinson N32 - Manual (Page 48)

4-4
Controls and Modes Mark Levinson
• Otherwise, the balance control automatically closes a few
seconds after the last command is received. If this occurs,
the selected setting is automatically applied.
The front panel balance LED remains lit if the left-to-right
channel balance of the main output connectors is offset.
Note
All Nº32 balance controls are deactivated when SSP mode is activated.
Mono Playback Mode
Mono playback mode sends mono (rather than stereo) signals to
the main output connectors, whether those signals are using the
balanced or unbalanced connectors. The mono playback control
has no affect on the record output connectors.
To toggle (switch) between mono and stereo playback:
On the remote control, press and release the mono button.
Mode L + R, L ONLY, R ONLY, L – R
Determines the mode of mono playback that is activated when the
remote control mono button is pressed. The factory-default MODE
parameter setting is L + R. Table 4-1 describes all mono playback
modes.
Table 4-1: Mono playback modes.
Mono Mode Description
L + R Sends an equal combination of left-channel
and right-channel input signals to the
left-channel and right-channel main output
connectors. See “Using the L + R Balance Con-
trol during mono playback” on page 4-5 for
additional information.