beautypg.com

Caution, Warning – Mark Levinson N32 User Manual

Page 14

background image

1-6

Getting Started

Mark Levinson

DO

allow at least 3 to 4 inches (8 to 10cm) of clearance above each

Nº32 chassis for proper heat dissipation.

DO

see See “Care & Maintenance” on page 5-4 for information

about routine care and maintenance.

DO

see “Nº32 Controller Dimensions” on page A-4 and “Nº32

Preamplifier Dimensions” on page A-5 for assistance with custom
installations.

DO NOT

place either Nº32 chassis on a thick rug or carpet or

cover either chassis with a cloth, as this might prevent proper
cooling.

DO NOT

expose either Nº32 chassis to high temperatures, humid-

ity, steam, smoke, dampness, or excessive dust. Avoid installing
either Nº32 chassis near radiators and other heat-producing
appliances.

DO NOT

install either Nº32 chassis near unshielded TV or FM

antennas, cable TV decoders, and other RF-emitting devices that
might cause interference.

DO NOT

place either Nº32 chassis on a windowsill or in another

location in which it will be exposed to direct sunlight.

DO NOT

obstruct the IR receiver/transmitter located on the right

side of the controller front panel display. When the Nº32 is not
using the IR input connector, the remote control IR transmitter
must be in line-of-sight with the front panel display IR receiver/
transmitter for proper remote control operation. See “Remote
Control” on page 2-10 for ad
ditional information.

Caution!

BEFORE moving the Nº32, make sure it is powered off with the
power button. Then, make sure the power cord is disconnected
from the ~ac mains connector and the electrical outlet.

Warning!

MAKE SURE all components are properly grounded. Do not
defeat the safety purpose of polarized or grounding-type plugs
with “ground-lifter” or “cheater” adaptors. Doing so may cause
dangerous voltages to build up between components. The pres-
ence of these voltages may result in personal injuries and/or
product damage.

Remote Control

Batteries

The remote control comes with two AAA alkaline batteries that
should be replaced as needed. It is recommended to use alkaline
batteries, which do not leak and last longer.