Mark Levinson N32 - Manual (Page 46)

4-2
Controls and Modes Mark Levinson
2. Press and release the standby button to cycle through all avail-
able SLEEP parameter settings.
3. When the desired setting is selected, press the enter button to
close the SLEEP parameter.
Otherwise, the SLEEP parameter automatically closes a few
seconds after the last command is received. If this occurs, the
selected setting is automatically applied.
Note
The SLEEP parameter is automatically set to –OFF– whenever the Nº32
is placed into standby.
Display Intensity
Display intensity controls the illumination of front panel display
characters as well as the front panel standby and preamplifier LEDs.
Four illumination levels are available, including FULL (100%),
HALF (50%), DIM (25%), and OFF (0%). The factory-default illumi-
nation level is FULL (100%).
When the OFF (0%) illumination level is selected:
• The front panel display automatically activates whenever a
change in status is detected.
• The front panel standby and preamplifier LEDs light at the
FULL (100%) illumination level.
To adjust display intensity:
Press the display intensity button to cycle through the four avail-
able illumination levels.
Front panel display characters, the front panel standby LED,
and the front panel preamplifier LED automatically adjust to
the selected illumination level.
Polarity
The polarity control sets the polarity of the main output signal. The
polarity control has no affect on the record output signal.
To adjust main output signal polarity:
Press the polarity button on the remote control.