Mark Levinson N32 - Manual (Page 43)

3-11
Nº32 Reference Preamplifier Setup Menu
Trig 12v,L; 5v,P
Configures the trigger output signal when the trigger input
connector is not in use. Selecting the 12v,L setting configures the
trigger output connector to send a 12V, level (constant) signal to
the connected component whenever the Nº32 is taken out of
standby. This signal is not present when the Nº32 is placed into
standby.
Selecting the 5v,P signal configures the trigger output connector to
send a 5V pulse signal, similar to that of a momentary contact
switch, to the connected component whenever the standby button
is pressed. This signal is only present when the standby button is
pressed.
Note
The Trig. parameter has no effect when a component is connected to
the trigger input connector. Instead, the Nº32 passes incoming trigger
signals to the component connected to the trigger output connector.
Sw Indicates the current software version operating in the Nº32.
Software upgrades can be performed with the RS-232 port, allowing
software to be upgraded without disassembling the Nº32 or discon-
necting it from other components.