Mark Levinson N32 - Manual (Page 42)

3-10
Setup Menu Mark Levinson
To teach Nº32 IR commands to a learning remote control:
1. Press the Nº32 setup button.
The setup button opens the setup menu. The front panel setup
LED lights red when the setup menu is open.
2. Rotate the select knob or press the select / buttons until
Teach IR appears on the front panel display.
3. Press the enter button to open the Teach IR menu.
The VOLUME UP IR command will appear on the front panel
display.
4. Rotate the volume knob or press the volume ± buttons to scroll
through all available IR commands.
5. When the desired IR command is selected, press the enter but-
ton to teach this command to the learning remote control.
The <- SENDING message will appear on the front panel display
to indicate that the associated infrared signal is being sent to
the learning remote control.
6. Repeat step 4 and step 5 until all desired IR commands have
been sent.
Note
The Nº31, Nº31.5, Nº37, Nº39, and Nº390S remote controls can
control Nº32 master volume level. This command is available over IR
(not Link connections). Before using one of these remote controls to
adjust Nº32 master volume level, make sure the digital transport setup
menu volume control parameter is set to fixed.
Setup Parameters
Mute –10.0dB to –80.0dB
Determines the amount of master volume level attenuation that
occurs when the mute button is pressed. The mute level can be set
in 0.1dB increments between –10.0dB and –80.0dB. The factory-
default mute level is –20.0dB.
MaxVol 40.0dB to 80.0dB
Determines the maximum master volume level setting in 0.1dB
increments between 40.0dB and 80.0dB. The factory-default
maximum master volume level is 80.0dB.