beautypg.com

Fireplace preparation, Warning – Monessen Hearth MJ27NR User Manual

Page 17

background image

86D0024

17

FP2005
damper install

Damper Stop

Damper

FP2005

BEFORE INSTALLING ThE APPLIANCE:
• Turn off gas supply to fireplace or firebox.
• Have the fireplace floor and chimney professionally cleaned to remove ashes, soot, creosote or other obstruc-

tions. Have this cleaning performed annually after installation.

• Seal any fresh air vents or ash clean-out doors located on floor or wall of fireplace. If not, drafting may cause

pilot outage or sooting. Use a heat-resistant

sealant.

Install and operate the appliance as directed

in this manual.

DAMPER STOP INSTALLATION:
A damper stop must be provided with the unit.

Contact your dealer to obtain one. The damper

stop must be installed as shown in Figure 12 to

prevent full closure of the fireplace damper blade

and provide a minimum 29 square inch flue opening.

Figure 12 - Damper Stop Installation.

FIREPLACE PREPARATION

BEFORE FULLY INSTALLING THE UNIT:
• Turn

OFF the gas supply to the fireplace or firebox.

• Seal any fresh air vents and/or ash clean-out doors located on the floor or wall of the fireplace. If left unsealed,

drafting may cause pilot outage or sooting. Use a heat resistant sealant.

Do not seal the chimney flue

damper.

INSTALLING vENTED APPLICATIONS

Manual and Millivolt controlled gas logs may be installed as a vented decorative log set in compliance with ANSI

Z21.60 and National Fuel Gas Code, Section 6.6.

Since, the gas logs are operated with the damper open,

non-combustible material and minimum mantel requirements do not apply.

W

ARNING

This appliance is for installation only in a solid fuel burning fireplace (masonry fireplace

or manufactured fireplace) with a working flue and constructed of noncombustible

material.
Exception:
DO NOT install this appliance in a factory-built fireplace that includes

instructions stating that it has not been tested or should not be used with unvented

gas logs. This log set may be installed as a vented log set.

W

ARNING

Before installing in a solid fuel burning

fireplace, The chimney flue and firebox must

be cleaned of soot, creosote, ashes and loose

paint by a qualified chimney cleaner.

W

ARNING

The fireplace and gas logs function as a system. If the fireplace is spilling into the room

(check with a match or a smoke stick), reposition the damper clamp until a positive

draft is obtained by opening the damper. If negative pressure in home prevents having

a positive draft, contact your dealer for assistance.

This manual is related to the following products: