Marathon Computer AACC 2000 - Manual (Page 49)

Marathon Monitors Inc.
AACC 2000 Carbon Nov. 1, 1997
49
Level selection
The ‘
Goto’ display allows you to select the
required access level.
Use and to select from the following
display codes:
OPEr: Operator level
FuLL: Full level
Edit: Edit level
conF: Configuration level
Press
If you selected either ‘
OPEr’, ‘FuLL’ or
‘
Edit’ level you will be returned to the
‘
ACCS’ list header in the level that you
chose. If you selected ‘
conF’, you will get
a display showing ‘
ConF’ in the upper
readout (see below).
Configuration password
When the ‘
ConF’ display appears, you must
enter the Configuration password in order to
gain access to this level. Do this by
repeating the password entry procedure
described in the previous section.
The configuration password is set to ‘
2’
when the controller is shipped from the
factory. If you need to change the
configuration password, see Chapter 6,
Configuration.
Press
Configuration level
The first display of configuration is shown.
See Chapter 6, Configuration, for details of
the configuration parameters.
For instructions on leaving configuration
level, see Chapter 6, Configuration.
Alternative path if
‘
conF’ selected