Marathon Computer AACC 2000 - Manual (Page 48)

Marathon Monitors Inc.
AACC 2000 Carbon Nov. 1, 1997
48
SELECTING AN ACCESS LEVEL
Access to Full, Edit or Configuration levels is protected by a password to prevent
unauthorised access.
If you need to change the password, see Chapter 6, Configuration.
Access list header
Press until you reach the access list header
‘
ACCS’.
Press
Password entry
The password is entered from the ‘
codE’ display.
Enter the password using or . Once the
correct password has been entered, there is a two
second delay after which the lower readout will
change to show ‘
PASS’ indicating that access is
now unlocked.
The pass number is set to ‘
1’ when the controller is
shipped from the factory.
Note; A special case exists if the password has
been set to ‘
0’. In this case access will be
permanently unlocked and the lower readout will
always show ‘
PASS’.
Press to proceed to the ‘
Goto’ page.
(If an incorrect password has been entered and the
controller is still ‘locked’ then pressing
returns
you to the ‘
ACCS’ list header.)
Access to Read-only Configuration
From this display, pressing and
together will take you into Read-Only
Configuration without entering a password.
This will allow you to view all of the
configuration parameters, but not adjust them.
If no button is pressed for ten seconds, you
will be returned to the Home display.
Alternatively, pressing
and together
takes you immediately back to the Home
display