Motorola 68014301013 - Manual (Page 9)

7 Installation
3 Remove adhesive backing from and press key tabs
(supplied) onto UIM:
• Place key at top position.
• Place \ key at bottom position.
4 Verify cable is fitted into a groove on the back of the
UIM. The cable must be contained in the slot to
provide a flat surface for mounting.
5 Connect cable connector P (shown on page 5) to the
vehicle integration kit connector B (shown on page 4).
6 Remove one side of mounting tape (supplied) and
press firmly onto rear of the UIM.
7 Remove other side of mounting tape and attach UIM to
flat spot location on your vehicle.
Use mounting bracket
To install the UIM using the mounting bracket:
Caution: The location of the UIM must not interfere with
the vehicle's air bag deployment.
1 Clean mounting surface thoroughly with an alcohol
wipe (not supplied).
2 Select UIM orientation (controls on left or right of
display).
Note: To change screen display orientation, see “Set
install preferences” on page 11.
3 Remove adhesive backing from and press key tabs
(supplied) onto UIM:
• Place key at top position.
• Place \ key at bottom position.
4 Verify cable is fitted into a groove on the back of the
UIM. The cable must be contained in the slot to
provide a flat surface for mounting.
optimal for
right-handed
operation
optimal for
left-handed
operation