Motorola Canopy Powerline MU - Manual (Page 59)

Powerline MU
Page 59 of 112
•
System: View and make changes in the system. View the system information
and logs. Set or change the time and date information, change the password,
backup the settings, reboot the system, and upgrade the Modem firmware.
•
Advanced: The Advanced screen gives you links for setting Packet Priority,
Bandwidth Control, SNMP Configuration and SNMP Access Control.
•
IP Address: Set the Modem to obtain an IP address automatically or to use a
specific IP address. Set WAN and DMZ attributes, if desired.
•
Powerline: Scan devices. Set the Network Encryption Key and view or change
PSD settings..
At the top of each screen is a Home link to go back to the System Information screen and
a Logout link to log out of the Modem.
7.2 POWERLINE MODEM SCREEN MAP
Use the following screen map to locate a screen.
System
System Info
Password
Logs
Reset
Backup
Site Info
Advanced
Packet Priority
Bandwidth Control
SNMP Configuration
SNMP Access Control
Operating Mode (Modem Repeater)
VLAN Configuration
IP Address
IP Configuration
WAN
DMZ
Powerline
Scan Devices
NEK Configuration
PSD Settings
7.3 CONFIGURING THE POWERLINE MODEM
Open an Internet browser (for example, Internet Explorer, Mozilla, or Firefox).
In the address field, type 192.168.1.98 (modem default IP address).
In the welcome screen, enter your User ID and password. The factory default User ID is
admin. The password is Motorola. The User ID and password are case sensitive.
Select Login.