Motorola DCT3080 - Manual (Page 42)

DCT3080 Installation Manual
36
Code Description When Error Occurs Action Required
Platform ID
found OOB frequencies (LED then
displays Eb 02, indicating
the software object download
was unsuccessful.) operator
Eb18 Object size
mismatch
After the LED displays dl,
indicating failed during
attempted download Contact headend
operator
Eb19 Object size
failed range
check
After the LED displays dl,
indicating failed during
attempted download Contact headend
operator
Eb20 Invalid SUDB
pointer
After plugging the terminal
into an electrical outlet to
begin the boot cycle None
Operational Check for the Remote Control
The operational check tests communication with the remote control:
Table 2-6
Operational check procedures
Feature Testing Procedure
Power on
Press
POWER
on the remote control to turn on the DCT3080.
Tune to the output channel (3 or 4).
Channel
selection
Scan through the channels using the
CHANNEL
+
or
-
keys.
Tune to several channels by entering the channel number using
the numeric keys.
Volume
control
Press
VOLUME +
or - on the remote control to increase the
volume to its upper limit, lowest level, and to a comfortable
level.
Press
MUTE
to turn the sound off. Press
MUTE
again to restore
the sound.
If the DCT3080 does not operate properly, refer to Section 5,
“Troubleshooting.”