Motorola DCT3080 - Manual (Page 39)

DCT3080 Installation Manual
33
Display Frequency Description
FR 7 107.25
MHz
Attempting to lock on frequency 7
FR 8 107.40
MHz
Attempting to lock on frequency 8
FR 9 110.25
MHz
Attempting to lock on frequency 9
FR 10 116.25
MHz
Attempting to lock on frequency 10
Au N/A
Authenticating code object (displays only after download)
ƒ When the correct OOB frequency is acquired, the LED flashes FR
number.
ƒ When multiple OOB frequencies are used, the DCT3080 pauses 40
seconds on each valid frequency. The LED displays dl and a
progress indicator, which identifies a software object download. The
progress indicator, or crawling ant, moves one position around the
dl
display for each segment of download received. If the dl stops
moving up and down on the LED for an extended period of time,
contact the headend operator.
The progress indicator usually moves at a consistent rate as segment
downloads are received. If all the segments are retrieved in the first
pass, the EF, AU, and FP messages are displayed on the LED. If
segments are dropped, the progress indicator appears to stall and then
inch forward after the dropped segments are retired.
The software download may take up to 45 minutes (or longer if the
system is experiencing high demand). As long as the progress indicator
is spinning, the download is progressing.
When the progress indicator alternates between rapid and sluggish
movement, this may indicate that the stream is spinning too fast for
existing plant conditions.
ƒ
When the software object download is complete, the LED displays:
EF For up to 60 seconds during flash erasure
FP For up to 60 seconds during flash programming