Motorola DCT3080 - Manual (Page 27)

DCT3080 Installation Manual
21
Installation Overview
You are connecting to a standard definition TV – Connect the
S
-
VIDEO
connector using an S-video cable, or connect the composite
VIDEO
connector using an RCA phono cable. If the TV only has a coaxial RF
input, connect it to the DCT3080
RF OUT connector.
Determine if you are connecting the audio to a home theater receiver or
directly to the TV:
ƒ
If the receiver or TV has an SPDIF input, use the optical spdif or
coaxial spdif outputs.
ƒ Otherwise, use the baseband left and right audio out outputs.
1 Locate the cabling diagram(s) that best match the subscriber
configuration.
ƒ Connect the audio and video cables in a manner matching that
diagram.
ƒ Determine if you are connecting to a data device (see “Data
Device Connections” in this section). For installation details,
refer to instructions included with the data device.
Connect the cable terminal to the coaxial cable wall outlet.
ƒ Perform the boot cycle, including the download to the terminal,
as described in “Boot Cycle” in this section.
2 Perform the operational check for the remote control.
ƒ Optimize the video settings. See “Optimizing Video Settings” in
this section.
Verify that the appropriate configuration information has been
downloaded using the addressable controller, such as the DAC 6000.