Matrox Electronic Systems II - Manual (Page 99)

Board input and output connectors 99
The connector used is a 30-pin male, 0.050 pitch right angle
connector. For customers planning to build their own cables,
parts can be purchased from:
This connector interfaces with a ribbon cable, 0.025 inch pitch
(0.635 mm), AWG #30 (solid wire).
VMChannel interface connector
The VMChannel interface allows Matrox Meteor-II
/Multi-Channel to share data with any Matrox imaging board
that has a VMChannel interface capable of performing the bus
controller function. A VMChannel backplane (available with
the GEN-BUS/... interconnect kits) must be inserted across the
VMChannel interfaces of the boards. For pinout information,
see VMChannel interface connector in Appendix B.
Auxiliary power supply input
For pinout information, see Auxiliary power supply input in
Appendix B.
Auxiliary power supply selection
For information, see Auxiliary power supply selection in
Appendix B.
1, 3, 5, 7,
9, 11, 13,
21, 25,
27 GND Ground.
■
Manufacturer: Fujitsu
■ Connector FCN-217J030-G/O
Pin Signal I/O Description