Matrox Electronic Systems II - Manual (Page 65)

Matrox Meteor-II /Digital grab section 65
.
Performance The video timing parameters supported by the Matrox
Meteor-II /Digital board are as follows:
VIA
VMChannel
PSG
UART
32
32
32
LUT
4 256x8-bit
or
2 4Kx16-bit
RS-232
Drivers
and
Receivers
RX
TX
/RTS
/CTS
RS-422/
LVDS*
Receiver
TTL
Buffers
Data
RS-422
Drivers
&
Receivers
/
LVDS*
Clk input
Clk output
Hsync input
Hsync output
Vsync input
Vsync output
Valid frames/line
Trigger
Exposure timer1
Exposure timer2
Aux 1 input
Aux 2 input
Aux 1 output
Camera CTRL1
Aux 2 output
Camera CTRL2
Camera CTRL3
Trigger
Opto-
coupler
Host 32-bit PCI bus
* Matrox Meteor-II is available with either RS-422 or LVDS support.
On separate bracket
Trigger
Exposure timer1
Exposure timer2
100-Pin
Connector
9-Pin Female
Trigger
Connector
9-Pin Male
Connector
RS-232
32
32
SGRAM
(4 MB)
64
Max
Number of pixels / line (including sync and blanking) 65536
Number of lines / frame (including sync and blanking) 65536
Sampling rate (LVDS, or LVDS with external clock input) 40 Mhz
Sampling rate (RS-422 or RS-422 with external clock input) 25 Mhz