Matrox Electronic Systems II - Manual (Page 59)

Matrox Meteor-II /Multi-Channel grab section 59
Performance The video timing parameters (including those for progressive
scan) supported by the Matrox Meteor-II /Multi-Channel board
are as follows:
Note that the maximum number of pixels per line that MIL
supports is:
Input channels
The Matrox Meteor-II /Multi-Channel has six independent
analog channels. These channels can support input from two
RGB or six monochrome cameras where the channels can be
selected with the MIL-Lite MdigChannel() command.
Low-pass filter
The input low-pass filtering stage is used to limit high
frequency noise and aliasing effects at the input of the triple
A/D converter. The filter used on Matrox Meteor-II
/Multi-Channel is a 4th order Butterworth filter with a cutoff
frequency of 10 MHz.
Gain
Matrox Meteor-II /Multi-Channel has adjustable gains. This
allows you to optimize the video input signal range.
Max
Number of pixels / line (including sync and blanking) 4096*
Number of lines / frame (including sync and blanking) 4096*
Sampling rate (with external clock input, or in
line-locking mode) 30 MSPS
Pixels
Line
-------------- x Number of Lines 4 Mbytes
≤