English – GIGABYTE AGP 4X(1.5V) User Manual
Page 54
- 50 -
GA-8PE667 Ultra2 / Pro Motherboard
English
)
)
)
)
)ACPI Suspend Type
S1(POS)
Set ACPI Suspend Type to S1/POS (Power On Suspend).
(Default value)
S3(STR)
Set ACPI Suspend Type to S3/STR (Suspend To RAM).
)
)
)
)
)Power LED in S1 State
Blinking
In standby mode(S1), power LED will blink. (Default Value)
Dual/Off
In standby mode(S1):
a. If use single color LED, power LED will turn off
.
b. If use dual color LED, power LED will turn to another color.
)
)
)
)
)Soft-off by PWR-BTTN
Instant-off
Press power button then Power off instantly. (Default value)
Delay 4 Sec.
Press power button 4 sec to Power off. Enter suspend if button is pressed less
than 4 sec.
)
)
)
)
)PME Event Wake up
0
When set at Enabled, any PCI-PM event awakes the system from a PCI-PM controlled
state.
0
This feature requires an ATX power supply that provides at least 1A on the +5VSB
lead.
Disabled
Disabled PME Event Wake up function.
Enabled
Enabled PME Event Wake up function. (Default Value)
)
)
)
)
)Modem Ring On/ WakeOnLAN
(When AC Back Function is set to [Soft-Off])
0
You can enable wake on LAN feature by the "ModemRingOn/WakeOnLAN" or "PME Event Wake
up" when the M/B has "WOL" onboard connector. Only enabled the feature by "PME Event Wake
up".
0
An incoming call via modem awakes the system from its soft-off mode.
0
When set at Enabled, an input signal comes from the other client/server on the LAN awaks the
system from a soft off state if connected over LAN.
Disabled
Disabled Modem Ring On / Wake On LAN function.
Enabled
Enabled Modem Ring On / Wake On LAN function. (Default Value)