GIGABYTE AGP 4X(1.5V) - Manual (Page 46)

- 42 - GA-8PE667 Ultra2 / Pro Motherboard
English
USB-ZIP Select your boot device priority by USB-ZIP.
USB-FDD Select your boot device priority by USB-FDD.
USB-HDD Select your boot device priority by USB-HDD.
ZIP Select your boot device priority by ZIP.
Disabled Disabled this function.
) ) ) ) )Boot Up Floppy Seek
0 0 0 0 0
During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. 360 K type is 40
tracks 720 K, 1.2 M and 1.44 M are all 80 tracks.
Enabled BIOS searches for floppy disk drive to determine it is 40 or 80 tracks. Note
that BIOS can not tell from 720 K, 1.2 M or 1.44 M drive type as they are
all 80tracks.
Disabled BIOS will not search for the type of floppy disk drive by track number. Note
that there will not be any warning message if the drive installed is 360 K.
(Default value)
& & & & & Password Check
System The system can not boot and can not access to Setup page will be denied
if the correct password is not entered at the prompt.
Setup The system will boot, but access to Setup will be denied if the correct
password is not entered at the prompt. (Default value)
& & & & & CPU Hyper-Threading
Enabled Enables CPU Hyper Threading Feature. Please note that this feature is only
working for operating system with multi processors mode supported.
(Default value)
Disabled Disables CPU Hyper Threading.
) ) ) ) )Init Display First
0 0 0 0 0 This feature allows you to select the first initation of the monitor display from which card, when
you install an AGP VGA card and a PCI VGA card on board.
PCI Set Init Display First to PCI Slot.
AGP Set Init Display First to AGP. (Default value)