Grizzly G0709 - Manual (Page 23)

Model G0709 (Mfg. Since 5/11)
-21-
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating
or correcting potential problems. if the
problem is not readily apparent, refer to
Troubleshooting on page 59.
11. Move the spindle on/oFF lever up to the
center position, and press the stop button.
12. Without resetting the stop button, move
the spindle on/oFF lever down. the machine
should not start.
—if the machine does not start, the stop
button safety feature is working correctly.
Continue to the next
Step.
—if the machine starts (with the stop button
pushed in), immediately disconnect power
to the machine. the stop button safety
feature is not working correctly. this safety
feature must work properly before pro-
ceeding with regular operations. Call tech
support for help.
13. rotate the stop button clockwise until it pops
out.
14. Make sure the lamp works.
15. Make sure that the cutting fluid nozzle is
pointing toward the chip pan, then turn the
cutting fluid pump switch
ON, and open the
nozzle valve. After verifying that cutting fluid
flows from the nozzle, turn the cutting fluid
switch
OFF.16. start the spindle, then step
on the brake pedal. the power to the motor
should be cut and the spindle should come to
an immediate stop.