GE Monogram Security Legend Camera - Manual (Page 8)

Legend
User Manual
4
4. At the enter site number display, enter the
number for the camera site you are
programming. This is a 3-digit number
(for example, 007, 021, 243).
You can enter one, two, or three digits
and press set (
).
Figure 7. Enter site number display
5. Continue entering commands with the
joystick.
Figure 8. See Monitor For Menus display
6. If passcodes are turned on, select your passcode level and enter your passcode (Figure 9). If passcodes
are turned off, you will be taken directly to the main programming screen (Figure 10).
You can now access any programming parameters that are allowed by your passcode.
Figure 9. Log on screen for the programming interface Figure 10. Main programming screen
ENTER CAMERA SITE
NUMBER _ _ _
" BACK
SEE MONITOR FOR MENUS
HOLD SEQ (3 SEC) TO EXIT