GE Monogram Security Legend Camera - Manual (Page 57)

53
Relay State screen ( Alarms | Relay State )
Figure 45. Relay State screen ( Alarms | Relay State )
Note: Remember to select OK to save any changes you make on the page.
Summary:
Name The Name column of the summary page lists both relays in numerical order,
whether programmed or not. The two relays are numbered 1 and 2.
Summary:
State The State column of the summary page lists the status of each programmed
relay as either on (active) or off (inactive).
Relay 1 on The Relay 1 on button lets you turn relay 1 on regardless of the current state
of any associated alarm.
Note: If you select Relay 1 on and select OK, then you are programming the dome to
activate this relay each time the dome is powered up.
Relay 1 off The Relay 1 off button lets you turn relay 1 off regardless of the current state
of any associated alarm.
Relay 2 on The Relay 2 on button lets you turn relay 2 on regardless of the current state
of any associated alarm.
Note: If you select Relay 2 on and select OK, then you are programming the dome to
activate this relay each time the dome is powered up.
Relay 2 off The Relay 2 off button lets you turn relay 2 off regardless of the current state
of any associated alarm.
Show relay state (check box) The Show relay state feature, when checked, lets you display the status of the
relays on the monitor screen at all times. If the status of alarms is also being
displayed, the relays will be listed at the bottom of the list after the alarms.