GE Monogram Security Legend Camera - Manual (Page 13)

9
ShadowTours
You have a total of 16 ShadowTours (totaling 20 minutes) that you can define for the dome. A ShadowTour is
a tour that the camera learns by recording your manual operation of the camera. Use a keypad to manually
direct the camera through the desired PTZ movements. The camera stores those movements in memory. The
recorded tour can be replayed at any time.
To program ShadowTours with the programming interface:
1. Access the programming interface. (For details, see Accessing the programming interface on page 3).
a. Press and hold the set ( ) key on the keypad until you hear a beep and the programming code
display appears on the keypad’s LCD.
b. Press the 9, 5, 1, and seq keys on the keypad.
c. Press 3 to select CAMERA.
Note: If you have an older keypad, the LCD will say CYBERDOME, instead of CAMERA, and you will have an
additional self-explanatory screen to step through.
d. Enter the number for the camera site you are programming.
The programming interface will appear on the monitor screen and you will start using the
joystick to enter commands.
e. If passcodes are turned on, select your passcode level and enter your passcode. If passcodes are
turned off, you will be taken directly to the main programming screen.
The programming interface will appear on the monitor screen and you will start using the
joystick to enter commands.
8. Press the iris+ or set ( ) key on the keypad to save (accept) the ShadowTour or press the iris- or
esc key to cancel (abort) the ShadowTour. Both canceling and saving the ShadowTour returns you to
the ShadowTour page.
9. After you have saved a ShadowTour, then you can use the other options on the ShadowTour page to
customize the tour’s title. See ShadowTours screen ( Actions | ShadowTours ) on page 38.
10. After programming your tours, you can verify them, one at a time, from within the programming
interface by selecting a tour number and Show. If you are out of the programming interface, you can
press the tour key on the keypad and the tour number to activate the desired tour.
2. Select Actions by guiding the joystick to
move the cursor over the Actions menu and
twisting the joystick knob.
3. Select ShadowTours.
4. Select a ShadowTour number.
5. Select Program.
6. Press and release the set ( ) key on the
keypad to start the ShadowTour timer.
7. Use the joystick to manually direct the
camera through the desired PTZ movements
Figure 14. ShadowTour programming page ( Actions | ShadowTours )