GE Monogram Security Legend Camera - Manual (Page 26)

Legend
User Manual
22
Settings screen ( Camera | Settings )
Page1 page ( Camera | Settings | Page1 )
Figure 28. Page1 page ( Camera | Settings | Page1 )
Note: Remember to select OK to save any changes you make on the page.
Day/Night Day/Night is a camera feature that switches the camera mode from color
(day) to monochrome (night) and removes the IR cut filter, which increases
the camera’s sensitivity in low light. It also allows the camera to function
with IR lighting.
Note: The Day/Night feature works only if the Exposure feature is set to Auto or
Return to auto. See
Interrelationship between the Exposure and Day/Night
features on page 64.
Choices are Automatic (default), Manual, and Disabled.
• Automatic: Enables the camera to automatically switch between
day (color) and night (monochrome) modes at a factory default light
level. The factory default is not changeable. You can briefly override
the day/night setting from the keypad. Within a few seconds, the
dome will return to the mode (day or night) determined by the
Automatic setting.
• Manual: Allows you to manually switch the camera between day
(color) and night (monochrome) modes using a command from the
controlling device (keypad, ASCII control software, etc.).
• Disabled: Allows you to disable (turn off) both the automatic and
manual modes. There will be no switching between the day and night
modes. Switching commands from the keypad are ignored. The dome
remains in the mode that it was in when Disabled was selected.