Gateway E3400 - Manual (Page 60)

Replacing the power supply 53
6 Insert the new power supply and slide it into the chassis until it engages
the connector.
7 Push the release level all the way in to secure the power supply.
8 Replace the right side panel. (See “Replacing the side panels” on page 23
for more information.)
9 Reconnect the power cord and all other cords you removed, then turn
on the system.
If the system does not start, make sure that you installed the power supply
correctly and that the voltage connector on the back of the power supply is
correctly set.
05957.book Page 53 Monday, May 8, 2000 10:09 AM