Gateway E3400 User Manual
Page 106
Error messages
99
Invalid password.
Enter your password again, making sure to
enter it correctly. Keep in mind that some
passwords are case-sensitive.
If you do not know the password, you may
need to reinstall the software you are trying to
access.
Startup passwords are stored in BIOS. If this
password has been set and is unknown, you
may be able to reset the password through
system board jumper settings.
Keyboard clock line failure.
Try a working keyboard.
Make sure the keyboard is compatible with the
system. You may have to change the switch
setting to AT.
Keyboard controller failure.
Try a working keyboard.
Make sure the keyboard is compatible with the
system. You may have to change the switch
setting to AT.
Keyboard not detected.
See “The keyboard does not work.” on
page 92 for possible solution.
Turn off the system, then check the keyboard
cable.
Keyboard stuck key failure.
Remove any objects that may be resting on the
keyboard, then restart the system.
Check for sticky keys. Clean the keyboard if
necessary.
Memory errors were detected
while the system powered up.
See “Memory errors were detected during
system start up.” on page 86 for possible
solution.
Memory size error.
Enter the BIOS Setup utility, then save the
memory configuration.
Non-system disk or disk
error.
Eject the diskette, then press
E
NTER
.
If the diskette is bootable, check it for errors.
Not enough memory.
Close all programs that are not currently in
use.
Error Message
Solutions
05957.book Page 99 Monday, May 8, 2000 10:09 AM