beautypg.com

Grizzly G0649 User Manual

Page 29

background image

g0649 Welding downdraft table

-27-

10. using warm soapy water, wash out the filter

cabinet and dust drawer, and allow them to
air-dry.

11. inspect for any seal or gasket damage and

replace as required.

12. Make sure you are wearing your respirator

and safety goggles.

13. Support the filter element and vacuum the

input side of the filter with a soft brush-type
tip while tapping the outside of the filter with
your other hand.

14. When you have removed most of the caked

contaminants, support the filter housing so it
will not fall over during the next step.

15. hold a shop air gun or spray nozzle no closer

than two to three feet from the filter element,
and in a slow and sweeping motion, blow
the remaining contaminants back out the
direction they came (

figure 36). Be careful,

however, if you get too close, the air pressure
may blow a hole in the filter.

16. place the vibrating filter into the cabinet.

17. reinstall the spring retaining bolt so

approximately 1" protrudes into the filter
cabinet.

figure 36. Vibrating filter element.

direction of

air Blowgun

pressure

7. Working from the back side of the machine,

reach into the cabinet, firmly grasp the
compression spring, and remove the spring
(

figure 34). the spring is under tension, so

make sure you do not lose your grip while
you work the spring out of the cabinet.

figure 33. removing spring retaining bolt.

8. repeat Step 6 on the remaining three

springs.

9. unplug the vibration motor, lift the vibrating

filter upward and pull the bottom outward
(

figure 35). place the unit on the floor.

figure 34. removing vibration filter spring.

figure 35. Vibration filter and motor.

Vibration

Motor