GE 60-883-95R - Manual (Page 22)

Programming Options 17
Option 36: Manual Mic Gain Range = 01-64 (Default = 64)
Determines the mic gain level (sensitivity) during 2-way audio sessions,
when manually switching between listen and talk.
Room size, acoustics, and furnishings where the panel is located will influ-
ence the setting. The available settings are 01 (low) to 64 (high). Entries
must be 2 digits.
¾ To program Manual Mic Gain:
1. Press Add.
2. Press Option #.
3. Press 3, then 6.
4. Enter the desired Manual Mic Gain using
the numbered buttons.
5. Press Done.
Option 37: VOX Receiver Gain Range = 01-10 (Default = 6)
Determines the receiver gain level during 2-way audio sessions.
If the VOX is switching the speaker on when the central station operator is
not talking, lower both this setting and Option 34: VOX Mic Gain. If the
VOX is not switching the speaker on when the central station operator is
talking, raise this setting and lower Option 34: VOX Mic Gain.
This option can be set from 01 to 10. Entries must be 2 digits.
Note
Changing this setting does not affect speaker volume.
¾ To program VOX Receiver Gain:
1. Press Add.
2. Press Option #.
3. Press 3, then 7.
4. Enter the desired VOX Receiver Gain using
the numbered buttons.
5. Press Done.
Option 38: Alarm Cancel Timeout Range = (Off), 003-254 Min (Default = 005)
Determines the number of minutes the user has to cancel an alarm. If the
alarm is cancelled within the Alarm Cancel Timeout period, an alarm cancel
report is generated.
Note
If this option is Off alarms cannot be cancelled and the panel will not announce “or
press Status to cancel.”
¾ To program Alarm Cancel Timeout:
1. Press Add.
2. Press Option #.
3. Press 3, then 8.
4. Enter the desired Alarm Cancel Timeout
using the numbered buttons.
5. Press Done.
Option 39: No Audio on Alarm Cancel Range = On/Off (Default = Off)
Determines if an audio session occurs after an alarm has been cancelled. By
default an audio session will occur after a cancelled alarm. Turn this option
on to disable audio after an alarm cancel.
¾ To Add or Delete No Audio on Alarm Can-
cel:
1. Press Add.
2. Press Option #.
3. Press 3, then 9.
4. Press Done.
Option 40: Report Medication Failures at Supervisory Time Range = On/Off (Default = Off)
If this option is on, a failure to take medication is reported to the central
monitoring station at Supervisory Time. When this option is off (default) a
failure to take medication is reported immediately. Pager and voice event
notifications occur immediately.
¾ To Add or Delete Report Medication Fail-
ure at Supervisory Time:
1. Press Add.
2. Press Option #.
3. Press 4, then 0.
4. Press Done.
Option 41: Activity Check Range = 02-48 Hours (Default = Off)
This option determines the number of hours that may pass without the Care-
Gard system detecting activity before a no activity alarm/report is generated.
¾ To Add or Delete Activity Timer:
1. Press Add.
2. Press Option #.
3. Press 4, then 1.
4. Enter the desired No Activity Hours using
the numbered buttons.
5. Press Done.