GE 60-883-95R - Manual (Page 20)

Programming Options 15
Option 27: RF Jam Detect Range = On/Off (Default = Off)
Determines whether the panel checks for and reports RF interference/jam to
the central station (on), or not (off).
If this option is on and the panel receives a constant 319.5 MHz signal, the
panel announces “RF interference detected” when the Status button is
pressed and reports the condition to the central station. If this option is off,
the panel does not detect an RF jam.
Note
The panel will not detect RF Jams for 4 hours after the initial power up or a mem-
ory clear.
RF Jam Detect must be turned on for ETL (UL 1635) listed systems.
¾ To Add or Delete RF Jam Detect:
1. Press Add or Delete.
2. Press Option #.
3. Press 2, then 7.
4. Press Done.
Option 28: Access Code Length Range = 3-6 (Default = 4)
Determines how many digits are in each access code.
This option lets you set the access code length to 3, 4, 5 or 6 digits. Turning
off (deleting) this option resets access code length and all access codes to
their default.
Read the following before changing this option.
• This option affects all access codes.
• Changing the access code length resets the Master, Utility 1 and Utility 2
access codes to their respective defaults as described in Table 6.
Note
If the customer wants the Access Code Length changed, it should be set before
programming any new (unprogrammed) access codes, whenever possible.
¾ To program Access Code Length:
1. Press Add.
2. Press Option #.
3. Press 2, then 8.
4. Enter the desired Access Code Length using
the numbered buttons.
5. Press Done.
Table 6: Access Code Length Defaults
Setting Default Code
3 Master - 123
Utility 1 - 321
Utility 2 - 321
4 Master - 1234
Utility 1 - 4321
Utility 2 - 4321
5 Master - 12345
Utility 1 - 54321
Utility 2 - 54321
6 Master - 123456
Utility 1 - 654321
Utility 2 - 654321
Option 29: RF Phone Answer Range = On/Off (Default = On)
When this option is on pressing a panic button or the panel call button will
answer a ringing phone. Pressing it again will hang-up the phone.
Important !
The phone must be hung up by pressing the panic button. If the phone is not hung
up the phone line may be held (unavailable) for up to 30 minutes.
Note
If a different panic than the one used to answer the phone is used to hang-up the
phone, the panel will disconnect and go into alarm.
¾ To Add or Delete RF Phone Answer:
1. Press Add or Delete.
2. Press Option #.
3. Press 2, then 9.
4. Press Done.