GE 60-883-95R - Manual (Page 14)

Programming Options 9
Option 2: Account Number Range = 0-9, A-F (Default = 00000)
Lets you program (Add) up to a 10-character alphanumeric account number.
Use the numbered buttons to enter numbers. To enter a letter, press the 9 but-
ton then use the Minutes + button to program letters A-F. Deleting this
option sets Account Number back to 00000.
Note
If Option 10 or 11 are set to Contact ID do not use the letter A in an account num-
ber.
¾ To program an Account Number:
1. Press Add.
2. Press Option #.
3. Press 0, then 2.
4. Enter the Account Number.
5. Press Done.
Option 3: Primary Phone Number Range = 26 Digits (Default = Off)
Lets you program (Add) a central monitoring station receiver phone number
for monitored systems (up to 26 digits long). Deleting this option sets it to
the default of Off.
When programming a Primary Phone Number use the Add button to enter a
* symbol. Use the Delete button to enter a # symbol. Use the Test button to
enter a pause.
Note
A primary phone number must be programmed for ETL (UL 1635) listed systems.
¾ To program a Primary Phone Number:
1. Press Add.
2. Press Option #.
3. Press 0, then 3.
4. Enter the Number using the numbered but-
tons and the Add, Delete, and Test buttons
as necessary.
5. Press Done.
Option 4: Secondary Phone Number Range = 26 Digits (Default = Off)
Lets you program (Add) a central monitoring station receiver/numeric
pager/voice event notification phone number (up to 26 digits long). Deleting
this options sets it to the default of Off.
When programming a Secondary Phone Number use the Add button to enter
a * symbol. Use the Delete button to enter a # symbol. Use the Test button to
enter a pause.
¾ To program a Secondary Phone Number:
1. Press Add.
2. Press Option #.
3. Press 0, then 4.
4. Enter the Number using the numbered but-
tons and the Add, Delete, and Test buttons
as necessary.
5. Press Done.
Option 5: Numeric Pager/Voice Event Notification Phone
Number
Range = 26 Digits (Default = Off)
Lets you program (Add) a phone number for numeric pager or voice event
notification (up to 26 digits long). Deleting this option turns it Off.
When programming a Numeric Pager/Voice Event Notification Phone Num-
ber use the Add button to enter a * symbol. Use the Delete button to enter a #
symbol. Use the Test button to enter a pause.
Note
It may be necessary to enter up to 5 pauses after a pager phone number in order
for it to work properly.
If the CareGard panel fails to report to a numeric pager, try adding pauses one at
a time until the system reports to the pager.
¾ To program a Numeric Pager/Voice Event
Notification Phone Number:
1. Press Add.
2. Press Option #.
3. Press 0, then 5.
4. Enter the Number using the numbered but-
tons and the Add, Delete, and Test buttons
as necessary.
5. Press Done.
Option 6: Call Waiting Range = 26 Digits (Default = Off)
Lets you program up to a 26-digit number or code that disables call waiting
or any other phone service before dialing central station, pager or voice
event notification phone number (on). When this option is turned off, the
panel dials only the central station or pager phone numbers.
¾ To program a Call Waiting code:
1. Press Add.
2. Press Option #.
3. Press 0, then 6.
4. Enter the Call Waiting code using the num-
bered buttons.
5. Press Done.