Gateway none - Manual (Page 27)

3-1
CHAPTER 3
C
HAPTER
3
CONFIGURING CLIENT TCP/IP
To access the Internet through the Gateway Broadband Router,
you must configure the network settings of the computers on
your LAN to use the same IP subnet as that defined for the
Gateway. The default network settings for the Gateway are:
IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
Note:These settings can be changed to fit your network
requirements, but you must first configure at least one
computer as described in Chapter 3 "Configuring
Client TCP/IP" to access the Gateway's Web configu-
ration interface. (See Chapter 4 "Configuring the
Gateway" for information on configuring the
Gateway.)
All PCs connected to the Gateway must be set to the same IP
subnet as the Gateway. The default subnet address of the
Gateway is 192.168.2.X (where X means 2-254) and the subnet
mask is 255.255.255.0. You can set the IP address for client PCs
either by automatically obtaining an IP address from the
Gateway's DHCP service or by manual configuration. See
Section 3.2 "Setting TCP/IP to Work with the Gateway".