Stovax E-Studio PR0776 - Manual (Page 26)

26
5
AR1999
2
• Carefully remove the enamel back panel by rotating it
out of the fire box, Diagram 3
5
AR1880b
3
TAKE EXTREME CARE whIlST REMOvING ThESE
PANElS NOT TO SCRATCh OR ChIP ThE PANEl ON
ThE SIDES OF ThE FIREBOX
• Unscrew the 3 fixings in the rear liner support, Diagram
4, and lift this part out of the appliance.
5
AR2000
4
• Remove the left and right-hand burner baffle brackets by
unscrewing the two fixings located on the burner tray top,
Diagram 5
SERvICING INSTRUCTIONS
REPlACING PARTS
1. GENERAl
1.1 All principal components can be replaced without removing
the appliance from its installation, although it is essential
that the gas supply to the appliance is turned off at the
isolation device before proceeding further.
1.2 Before replacing some of the components it will first be
necessary to remove the burner assembly from the
appliance by following the instructions below.
1.3 If for any reason the flue has to be removed from the
appliance, the seal must be replaced in the inner spigot.
2. REMOvING ThE BURNER UNIT
Ensure the appliance is cold before proceeding
2.1 • Turn the gas supply off at the isolation device. Then
disconnect the supply pipe.
• Remove the frame from the appliance by referring to the
separate frame instructions supplied.
2A. E-STUDIO
• Remove the one-piece glass window frame by removing
the eight fixing screws, Diagram 1
5
AR1996
1
• Remove the granite chippings from the appliance.
• Remove the top inner baffle by unscrewing the two fixing
screws located on the front edge of the top plate, Diagram2