Grizzly G0651 - Manual (Page 72)

-70-
model g0651/g0652 (mfg. since 1/10)
Figure 116. 90° stop bolt and jam nut (table
removed for clarity).
90° stop Bolt
& Jam nut
6. tighten the jam nut, then close the motor
cover.
Setting 45° Stop Bolt
1. disConneCt saW From poWer!
2. raise the blade as high as it will go, then tilt it
towards 45° until it stops and cannot be tilted
any more.
3. place a 45° square against the table and
blade so it contacts the blade evenly from
bottom to top, as shown in
Figure 117. make
sure a blade tooth does not obstruct the
placement of the square.
Figure 117. Checking blade at 45°.
7aVYZ
)*•HfjVgZ
IVWaZ
—if the blade is 45° to the table, then adjust-
ments do not need to be made.
—if the blade is not 45° to the table, you will
need to adjust the 45° stop screw. proceed
to the next step.
4. tilt the blade to 20°, so there is room for the
stop bolt to move.
5. loosen the jam nut on the 45° stop bolt (see
Figure 118) then adjust the stop bolt in or out
according to how far off the blade was from
45°.
6. Continue adjusting the stop bolt until it con-
tacts the cabinet when the blade is at 45°,
then tighten the jam nut.
7. reconnect the power, then recalibrate the
digital readout (refer to procedure on page
79) before operating the table saw.
Figure 118. 45° stop bolt and jam nut.
45° stop Bolt
Jam nut