Grizzly G0651 - Manual (Page 34)

-32-
model g0651/g0652 (mfg. since 1/10)
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate this machine.
however, because of the many variables involved
with shipping, we recommend that you verify the
following adjustments to ensure that your new
saw cuts safely and accurately.
step-by-step instructions for these adjustments
can be found in
SEcTION 7: SERVIcE.
Adjustments that should be verified:
1. Blade tilt stop accuracy (page 69).
2. miter slot parallel to Blade (page 71).
Recommended
Adjustments
Final Setup
the remaining tasks required for assembling the
saw include the following steps: installing the
table insert and cutting a slot for the blade, check-
ing fence parallelism, installing the blade guard,
and calibrating the blade angle digital readout.
To complete the remaining assembly steps:
1. disConneCt saW From poWer!
2. install and cut the table insert, as instructed
in cutting a zero clearance Insert, on page
42, then proceed to the next step.
3. verify that the fence is parallel to the blade/
miter slot and that this setting did not change
during shipping (refer to "Clamping pressure
and parallelism" on
page 76). the blade was
set parallel with the miter slot at the factory—
this affects whether the fence is parallel when
mounted to the table.
4. install the blade guard as instructed in
"installing Blade guard & spreader" on page
38.
5. Calibrate the digital readout before operating
the saw (refer to page 79 for instructions.)
each time power is disconnected the digital
readout will also need to be recalibrated.