Grizzly G0651 - Manual (Page 71)

model g0651/g0652 (mfg. since 1/10)
-69-
Blade Tilt Stops
the table saw features stop bolts that stop the
blade exactly at 45° and 90° during blade adjust-
ments.
the stops have been set at the factory and
should require no adjustments, unless you notice
that your cuts are not accurate.
Note: The tilt scale reads "0" when the blade is
90° to the table.
Tools Needed Qty
90 ° square ........................................................ 1
Combo square .................................................. 1
Wrench 12 & 13mm ........................................... 1
hex Wrench 2.5mm ........................................... 1
90° stop Bolt
& Jam nut
Figure 115. 90° stop bolt and jam nut.
mounting
plate
Setting 90° Stop Bolt
1. disConneCt saW From poWer!
2. raise the blade as high as it will go, then tilt
it toward 0° until it stops and cannot be tilted
any more.
3. place a 90° square against the table and
blade so it contacts the blade evenly from
bottom to top, as shown in
Figure 113. make
sure a blade tooth does not obstruct the
placement of the square.
—if the blade is 90° to the table, then adjust-
ments do not need to be made. make sure
the tilt indicator arrow shown in
Figure 114
points to the 0° mark on the scale. if it does
not, remove the blade height lock knob,
loosen the blade height handwheel set
screw and remove the handwheel.
Figure 113. Checking blade at 90°.
IVWaZ
.%•HfjVgZ
7aVYZ
Figure 114. tilt indicator arrow.
phillips head
screw
indicator
—if the blade is not 90° to the table, you will
need to adjust the 90° stop screw. proceed
to the next step.
4. tilt the blade to about 20°, so there is room
for the stop bolt to move.
5. open the motor access cover, loosen the jam
nut shown in Figures 115 & 116, adjust the
stop bolt up or down according to how far off
the blade was from 90°, then repeat
Step 3
until the blade stops at 90°.
adjust the indicator position by loosening
the phillips head screw, moving the indica-
tor, then tightening the screw and reinstall-
ing the handwheel. proceed to
Setting 45º
Stop Bolt on page 70.