FIC A360 - Manual (Page 46)

Installation and Upgrade
2. To remove the modem module, press the locking tabs away from the sides of the module
until the module pops up. Then, remove the modem module.
3.
Reassemble the notebook components as follows:
− Put the Mini-PCI Socket Compartment door back.
− Replace the screw.
− Turn the system over.
4.
Boot Windows from your hard disk and insert the disc containing the Modem driver for
Windows.
5.
Click the Start button and then click Run. In the Run dialog box, click Browse button
and navigate to the directory as "\driver\Win98\MODEM\setup.exe" where the
modem driver is located. . Please change "Win98" to other path named as WinMe,
Win2K… to fit the operating system you are using.
6.
Click OK to process the installation of modem driver. Follow the instruction to finish
the installation.
7.
With “Yes, I want to restart my computer now” selected, click Finish to complete the
modem installation.
2.2.9 Installing Internal LAN Device Driver
Your notebook computer may come with an optional internal LAN, which uses the Intel
82559 chip. Please follow the procedures below for installing the LAN driver:
Installing Internal LAN for Windows 98
1. Boot Windows 98 from your hard disk and insert the disc containing the LAN driver for
Windows 98.
2. Click the Start button, then click Settings, and Control Panel. Double click System and
click Device Manager tab. Under Other Devices, you'll see PCI Ethernet Controller.
3. Click Refresh button. The Add New Hardware Wizard will detect PCI Ethernet
Controller. Click Next to search for the driver.
4. Click Next to continue.
5. Tick Specify a location and click Browse button. Then, navigate to
"\Drivers\Win98\LAN" and click Next.
6. Click Next to accept the updated driver for Intel 82559 Fast Ethernet LAN driver.
7. Click Next to continue with LAN driver installation.
8. Insert the disk labeled "Windows 98 Second Edition CD-ROM", and then click OK.
9. Type "\Win98", then click "OK".
10. Click Finish to complete installation.
11. Restart Computer to finish setting up LAN.
Installing Internal LAN for Windows Me
1. Boot WinMe from your hard disk and insert the disc containing the LAN driver for
WinMe. The New Hardware Found Message box appears.
2. You will find the message stated searching PCI Ethernet Controller Device driver
showed in the Add New Hardware Wizard message box.
3. Select "Specify the location of the driver", and click Next.
4. Tick on "Specify a location box". Then, click Browse button and navigate to the LAN
FIC A360 Service Manual 2-7